Kronalux® Aggregate 759

• Very fast loading
• Good light reflection
• Full-surface application
• High mechanical load-bearing capacity
• Refractive index Class A ≥ 1.5
• Good grip Round beads for less soiling than sharp-edged quartz sand
• System product for BASt-compliant marking for road marking 750HS

Application

Sprinkle a surplus of the topcoat into the fresh marking or floor coating. The coating must be applied in a wet layer of at least 150 µ to ensure that the topcoat can adhere well. After drying, sweep off any non-adhering beads. For floor coatings, the primer is usually scattered with 864 Kronen Spezial Grundierharz or the first layer of the colored coating and then painted over again. Scatter markings and coatings for reflection in the last top coat. The fewer layers are applied over the topcoat, the greater the roughness and therefore the slip resistance and soiling.

Number of coats

As marking: 1x by hand into the damp marking

Consumption

Approx. 285 g/m² to 800 g/m² mm depending on the coating agent

Note

Post-spreading agent increases skid resistance but also soiling

Product properties

750HS Road marking with 285 g / m² in the top layer of 400 µ

Type I marking: Skid resistance: S1, night visibility dry: R4, day visibility: Q5, roll-over visibility: T2

757 2-component PU industrial marking with 100 g / m² in the top coat slip resistance class R13

380 Aqualine marking paint with 50 g / m² in the top coat slip resistance class R11

853 2-component PU floor coating with 500 g / m² in the primer 864 slip resistance class R12

763 2-component roll-on plastic 800 g / m² in the top coat