Real Rust Sealer 925

Instructions for using Real Rust Seal 925

1. Preparing the surface

Real Rust 986 should be allowed to dry thoroughly for at least 48 hours. The surface should then be dusted. If possible, wet cleaning can also be carried out to remove rust dust and any remaining salts and acids.

2. Application
 

The product must be stirred thoroughly before use. The following conditions must be observed throughout the entire application and drying time:

• The temperature of the material, substrate, and air must not be below 15°C or above 30°C.
• The relative humidity should be between 30% and 70%.

Low temperatures and high humidity can prolong the drying time.
 

3. Coating structure

Depending on the level of exposure, 1 to 3 coats are required:

• Base coat: This should be diluted with 30–50% water.
• Additional coats: These can be applied diluted up to 20%.
   

For light indoor use, one base coat is sufficient to protect against discoloration. In unprotected outdoor areas or in cases of heavy use, the sealed surface should be additionally protected with 2K Aqua Wet Room Sealant 677. It is important not to work on surfaces with standing water.